What to do if the cesspool fills up quickly

If in a private house the sewer system is equipped with a cesspool, then it should be remembered that such a pit needs to be serviced periodically by calling a sewer machine.

Usually, with the correct calculation of the volume of the pit, it is enough to use such services once a year.

But, many owners of country houses notice that after several years of operation, the cesspool fills up too quickly, and it has to be cleaned more often.

There are several signs that make it clear that the pit is filling up too quickly:

And if it is clear that the cesspool is filling up too quickly, what to do with this problem can be determined by identifying the cause of the accelerated filling.

There are several main reasons:

This is what a frozen stock looks like

Depending on the cause, you may be able to figure out what to do to keep the cesspool from filling up so quickly.

What to do when silting the bottom of the pit

The first, and most important reason why the cesspool quickly fills up is the silting of the bottom, especially if there is drainage below, through which part of the runoff in the form of water enters the ground.

Silting occurs in any case, but accelerates if fats, detergents, large fractions of waste, toilet paper get into the drain.

And if the cesspool is silted up, what to do is easy to understand.

Your actions should look like this:

So the principle of solving the problem is clear, if a cesspool has silted up, what to do with this problem is also clear.

After the cleaning procedure, the sewer will work properly for several years.

In the future, when you notice again that the drain pit has silted up, what to do, you will already know for sure.

It should be noted that if the silting of the bottom happened in winter, biological preparations in this case will be absolutely useless.

To solve the problem, chemical agents should be used, which are nitrate oxidizing agents.

They quickly liquefy the silty environment, reduce the amount of residual mass, eliminate the unpleasant smell from the cesspool.

But, chemicals will be ineffective if the drains in the pit are frozen.

Cesspool chemical preparation

If you continue to notice that the drain pit is quickly filling up, what to do in this case, we will consider further.

It is necessary to equip a new cesspool. At the same time, the old one does not need to be buried.

They should be connected with a pipe. Then you have a septic tank.

In the first pit, the effluents will be processed using natural processes and settled, decomposing into water and fractions.

Purified water will be able to flow into the next container, from which, after additional purification, it will seep into the soil through the drainage.

So the number of drains in the first pit will be significantly less, the sewer system will work more efficiently.

It looks like two cesspools connected by a pipe

Many in such cases decide to simply deepen the first drain hole. But still, the previously described method of solving the problem will be an order of magnitude more effective.

Moreover, it is quite simple to implement it.

What to do when the cesspool freezes

There may be sewage problems in the winter. The main reason for their occurrence is the freezing of drains.

That is why in the cold season the water in the cesspool does not go away. How to proceed in such a case?

The problem is solved quite simply. You need to take a copper wire, which is designed for 2 kW, prepare a metal pin, about 20 cm long, as well as a small hook.

So the cesspool is defrosted in winter. But this method should only be used if you are experienced with electricity.

At the same time, it is necessary to work in rubber boots. If there are no skills, such actions can be dangerous, then they should be entrusted to a specialist.

Protective special clothing (gloves and rubber boots)

If only the drain pipe is frozen, it should be wrapped once with bare copper wire. Determining the length of the conductor is quite simple.

You need to multiply the diameter of the pipe by 3.14. Subsequently, the wire is connected to the mains, leaving it like that for a couple of hours.

After this time, the network is de-energized, the wire is removed from the pipe. When carrying out such work, it is necessary to exclude the presence of children and animals in the immediate vicinity.